What is this syntax, Bplus? IDE refuses to read the source code. What are those semicolons at the end of lines? Is it even QB64?
Ah, so it's not your fault, BPlus, it's probably the forum's fault. That source code - I don't know if you have the same output as me, but it destroys the source code by adding nonsense to it.
For example, line 7 shows up for me here as
cx = _Width / 2: cy = _Height / 2: r = 100: c~& = &HFF8888FF
When I manually fixed it everywhere (by deleting amp; ) I got it running.
Better is using source box without text formating (QB)
Ah, so it's not your fault, BPlus, it's probably the forum's fault. That source code - I don't know if you have the same output as me, but it destroys the source code by adding nonsense to it.
For example, line 7 shows up for me here as
cx = _Width / 2: cy = _Height / 2: r = 100: c~& = &HFF8888FF
When I manually fixed it everywhere (by deleting amp; ) I got it running.
Better is using source box without text formating (QB)