Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Using WiringPI c-lib in QB64
#3
Thank You very much DSMan for Your professional info.

I 'm going to try it out this week.

Therefore I'm going to solder a simple NTC - resistor or NTC-resistor-capacitor circuit on a little test-board.
If a got it working I 'll publish the result.

For later:
Reading the value of a pin gives also the possibility to use also a Platina based temperature sensor.
Advantages: Relative linear response, quick response... etc...  (better and quicker than NTC)

Example of such sensor:
https://www.reichelt.nl/nl/en/platinum-t...GE=EN&&r=1

Rudy M
Reply


Messages In This Thread
Using WiringPI c-lib in QB64 - by Rudy M - 07-02-2024, 08:56 AM
RE: Using WiringPI c-lib in QB64 - by DSMan195276 - 07-07-2024, 08:12 PM
RE: Using WiringPI c-lib in QB64 - by Rudy M - 07-08-2024, 08:43 AM



Users browsing this thread: 1 Guest(s)