Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Drawing Tools Subs or Functions with Demo
#48
Oh heck I just found a fix I made in 2022, instead of EndRadianAngle it adds a arc measure in radians to the StartRadianAngle:

Code: (Select All)
Sub drawArc (xc, yc, radius, rStart, rMeasure, colr As _Unsigned Long)
    ' xc, yc Center for arc circle
    ' rStart is the Radian Start Angle, use _D2R for conversion from Degrees to Radians
    ' rMeasure is the measure of Arc in Radain units, use _D2R for conversion from Degrees to Radians
    ' Arc will start at rStart and go clockwise around for rMeasure Radians

    Dim rEnd, stepper, a, x, y

    rEnd = rStart + rMeasure
    stepper = 1 / radius ' the bigger the radius the smaller  the steps
    For a = rStart To rEnd Step stepper
        x = xc + radius * Cos(a)
        y = yc + radius * Sin(a)
        If a > rStart Then Line -(x, y), colr Else PSet (x, y), colr
    Next
End Sub

'Arc New 2022-09-28 independent of constants and routines
Sub drawPieSlice (xc, yc, radius, rStart, rMeasure, colr As _Unsigned Long)
    ' xc, yc Center for arc circle
    ' rStart is the Radian Start Angle, use _D2R for conversion from Degrees to Radians
    ' rMeasure is the measure of Arc in Radain units, use _D2R for conversion from Degrees to Radians
    ' Arc will start at rStart and go clockwise around for rMeasure Radians

    Dim rEnd, stepper, a, x, y

    rEnd = rStart + rMeasure
    Line (xc, yc)-(xc + radius * Cos(rStart), yc + radius * Sin(rStart)), colr
    Line (xc, yc)-(xc + radius * Cos(rEnd), yc + radius * Sin(rEnd)), colr
    stepper = 1 / radius ' the bigger the radius the smaller  the steps
    For a = rStart To rEnd Step stepper
        x = xc + radius * Cos(a)
        y = yc + radius * Sin(a)
        If a > rStart Then Line -(x, y), colr Else PSet (x, y), colr
    Next
    Paint (xc + .5 * radius * Cos(rStart + .5 * rMeasure), yc + .5 * radius * Sin(rStart + .5 * rMeasure)), colr, colr
End Sub
b = b + ...
Reply


Messages In This Thread
RE: Drawing Tools Subs or Functions with Demo - by bplus - 10-14-2024, 04:31 PM



Users browsing this thread: 9 Guest(s)