07-16-2022, 03:50 PM
I have started converting 3 of a family of inter-related QB programs to QB64 and have run into the issue of getting the Windows message:
"program" has stopped working
A problem caused the program to stop working correctly.
Windows will close the program etc, etc.
The message is not immediate but comes up within a minute on all 3.
Each program can start another using RUN. Sometimes the message appears when another program loads but before the program itself displays its screen.
Within one program I do some data file access and after pulling up records a few times the error appears.
Any suggestions on how to diagnose or eliminate the issue?
Thanks,
"program" has stopped working
A problem caused the program to stop working correctly.
Windows will close the program etc, etc.
The message is not immediate but comes up within a minute on all 3.
Each program can start another using RUN. Sometimes the message appears when another program loads but before the program itself displays its screen.
Within one program I do some data file access and after pulling up records a few times the error appears.
Any suggestions on how to diagnose or eliminate the issue?
Thanks,