Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
z switch does nothing
#2
Note what is the time you run "qb64pe" program.

Compile your program with "-z" switch.

Then look into your "qbpe/internal/temp" directory.

Make sure there is anything in there which is very close to the time (ie. a few seconds later) you fired the "qb64pe" program.
Reply


Messages In This Thread
z switch does nothing - by Jack - 09-07-2022, 01:58 AM
RE: z switch does nothing - by mnrvovrfc - 09-07-2022, 03:36 AM
RE: z switch does nothing - by Jack - 09-07-2022, 12:15 PM



Users browsing this thread: 1 Guest(s)