UNTIL

From QB64 Phoenix Edition Wiki
Jump to navigation Jump to search

The UNTIL condition is used in DO...LOOP exit verifications.


Syntax

DO [UNTIL] evaluation
.
.
.
LOOP UNTIL evaluation


  • Only one conditional evaluation can be made at the start or the end of a DO...LOOP.
  • DO UNTIL evaluates a condition before and inside of the loop. The loop may not run at all.
  • LOOP UNTIL evaluates a condition inside of the loop. It has to loop once.
  • Skips the loop or loops until an evaluation becomes True.


         Table 3: The relational operations for condition checking.

 In this table, A and B are the Expressions to compare. Both must represent
 the same general type, i.e. they must result into either numerical values
 or STRING values. If a test succeeds, then true (-1) is returned, false (0)
     if it fails, which both can be used in further Boolean evaluations.
 ┌─────────────────────────────────────────────────────────────────────────┐
 │                          Relational Operations                          │
 ├────────────┬───────────────────────────────────────────┬────────────────┤
 │ OperationDescriptionExample usage  │
 ├────────────┼───────────────────────────────────────────┼────────────────┤
 │   A = B    │ Tests if A is equal to B.                 │ IF A = B THEN  │
 ├────────────┼───────────────────────────────────────────┼────────────────┤
 │   A <> B   │ Tests if A is not equal to B.             │ IF A <> B THEN │
 ├────────────┼───────────────────────────────────────────┼────────────────┤
 │   A < B    │ Tests if A is less than B.                │ IF A < B THEN  │
 ├────────────┼───────────────────────────────────────────┼────────────────┤
 │   A > B    │ Tests if A is greater than B.             │ IF A > B THEN  │
 ├────────────┼───────────────────────────────────────────┼────────────────┤
 │   A <= B   │ Tests if A is less than or equal to B.    │ IF A <= B THEN │
 ├────────────┼───────────────────────────────────────────┼────────────────┤
 │   A >= B   │ Tests if A is greater than or equal to B. │ IF A >= B THEN │
 └────────────┴───────────────────────────────────────────┴────────────────┘
   The operations should be very obvious for numerical values. For strings
   be aware that all checks are done case sensitive (i.e. "Foo" <> "foo").
   The equal/not equal check is pretty much straight forward, but for the
   less/greater checks the ASCII value of the first different character is
                          used for decision making:

   E.g. "abc" is less than "abd", because in the first difference (the 3rd
        character) the "c" has a lower ASCII value than the "d".

   This behavior may give you some subtle results, if you are not aware of
                   the ASCII values and the written case:

   E.g. "abc" is greater than "abD", because the small letters have higher
        ASCII values than the capital letters, hence "c" > "D". You may use
        LCASE$ or UCASE$ to make sure both strings have the same case.


See also



Navigation:
Main Page with Articles and Tutorials
Keyword Reference - Alphabetical
Keyword Reference - By usage
Report a broken link