UNTIL
Jump to navigation
Jump to search
The UNTIL condition is used in DO...LOOP exit verifications.
Syntax
- DO [UNTIL] evaluation
- .
- .
- .
- LOOP UNTIL evaluation
- Only one conditional evaluation can be made at the start or the end of a DO...LOOP.
- DO UNTIL evaluates a condition before and inside of the loop. The loop may not run at all.
- LOOP UNTIL evaluates a condition inside of the loop. It has to loop once.
- Skips the loop or loops until an evaluation becomes True.
Table 3: The relational operations for condition checking. In this table, A and B are the Expressions to compare. Both must represent the same general type, i.e. they must result into either numerical values or STRING values. If a test succeeds, then true (-1) is returned, false (0) if it fails, which both can be used in further Boolean evaluations. ┌─────────────────────────────────────────────────────────────────────────┐ │ Relational Operations │ ├────────────┬───────────────────────────────────────────┬────────────────┤ │ Operation │ Description │ Example usage │ ├────────────┼───────────────────────────────────────────┼────────────────┤ │ A = B │ Tests if A is equal to B. │ IF A = B THEN │ ├────────────┼───────────────────────────────────────────┼────────────────┤ │ A <> B │ Tests if A is not equal to B. │ IF A <> B THEN │ ├────────────┼───────────────────────────────────────────┼────────────────┤ │ A < B │ Tests if A is less than B. │ IF A < B THEN │ ├────────────┼───────────────────────────────────────────┼────────────────┤ │ A > B │ Tests if A is greater than B. │ IF A > B THEN │ ├────────────┼───────────────────────────────────────────┼────────────────┤ │ A <= B │ Tests if A is less than or equal to B. │ IF A <= B THEN │ ├────────────┼───────────────────────────────────────────┼────────────────┤ │ A >= B │ Tests if A is greater than or equal to B. │ IF A >= B THEN │ └────────────┴───────────────────────────────────────────┴────────────────┘ The operations should be very obvious for numerical values. For strings be aware that all checks are done case sensitive (i.e. "Foo" <> "foo"). The equal/not equal check is pretty much straight forward, but for the less/greater checks the ASCII value of the first different character is used for decision making: E.g. "abc" is less than "abd", because in the first difference (the 3rd character) the "c" has a lower ASCII value than the "d". This behavior may give you some subtle results, if you are not aware of the ASCII values and the written case: E.g. "abc" is greater than "abD", because the small letters have higher ASCII values than the capital letters, hence "c" > "D". You may use LCASE$ or UCASE$ to make sure both strings have the same case. |
See also: